Đang chuẩn bị liên kết để tải về tài liệu:
PRACTICAL GUIDE TO INDUSTRIAL SAFETY: Methods for Process Safety Professionals - Chapter 7

An toàn trong phòng thí nghiệm Thiết lập INTRODUCTIONLaboratory hiện vấn đề an toàn đặc biệt vì số lượng lớn các hoá chất khác nhau đó là thường xử lý. Nhiều hóa chất không tương thích thường, và vào mùa thu Chẳng hạn như loại vật liệu dễ cháy, các sản phẩm dễ cháy, nước phản ứng và không ổn định, khí nén, tự cháy, đông lạnh, ăn mòn, chất nổ và chất độc hại. Thực hành quản lý an toàn đòi hỏi phải cẩn thận Hãy Cho đến xử lý đặc biệt và lưu trữ các tài liệu này, cũng như. | Chapter 7 SAFETY IN THE LABORATORY INTRODUCTION Laboratory settings present special safety problems because of the large number of different chemicals that are often handled. Many chemicals are often incompatible and fall into such categories as flammable materials combustible products water reactive and unstable compressed gases pyrophoric cryogenic corrosive explosive and toxic. Safe management practices require attention be given to special handling and storing of these materials as well as proper disposal. This chapter focuses on safe handling practices for common laboratory environments. Examples of specific chemicals and proper handling practices are reviewed and specific recommendations for a number of common chemicals encountered in laboratories are provided. The Web sites noted in the last chapter are a good source for obtaining the MSDSs of many of the chemicals discussed in this chapter. COMPRESSED AND LIQUEFIED GASES Compressed and liquefied gases should be used and handled only by properly trained personnel. Some of the most widely used gases in a laboratory are acetylene hydrogen methane propane carbon monoxide and natural gas. This section describes the hazardous properties of these gases and provides recommendations for gas storage and handling. Table 1 provides some properties of common flammable gases. Other sources of information on gases include MSDSs the Matheson Gas Data Book Compressed Gas Association pamphlets such as C-6 Standards for Visual Inspection of Steel Compressed Gas Cylinders and C-8 Standard for Re-qualification of DOT-311t Seamless Steel 381 Copyright 2001 Marcel Dekker Inc. 382 CHAPTER 7 Cylinders and NFPA publications. The MSDSs and the Matheson Gas Data Book deal chiefly with properties and use of gases and components of gas systems pamphlets from the Compressed Gas Association deal with standards and requirements of the Department of Transportation. The NFPA National Fuel Gas Code describes appropriate containers and .