Đang chuẩn bị liên kết để tải về tài liệu:
Electronics and Circuit Analysis Using MATLAB P7

This chapter discusses the application of MATLAB for analysis of two-port networks. The describing equations for the various two-port network representations are given. The use of MATLAB for solving problems involving parallel, series and cascaded two-port networks is shown. Example problems involving both passive and active circuits will be solved using MATLAB. 7.1 TWO-PORT NETWORK REPRESENTATIONS A general two-port network is shown in Figure 7.1. I1 + V1 Linear two-port network I2 + V2 - Figure 7.1 General Two-Port Network I 1 and V1 are input current and voltage, respectively. Also, I 2 and V2 are output current and voltage, respectively. It is assumed that the linear. | Attia John Okyere. Two-Port Networks. Electronics and Circuit Analysis using MATLAB. Ed. John Okyere Attia Boca Raton CRC Press LLC 1999 1999 by CRC PRESS LLC CHAPTER SEVEN TWO-PORT NETWORKS This chapter discusses the application of MATLAB for analysis of two-port networks. The describing equations for the various two-port network representations are given. The use of MATLAB for solving problems involving parallel series and cascaded two-port networks is shown. Example problems involving both passive and active circuits will be solved using MATLAB. 7.1 TWO-PORT NETWORK REPRESENTATIONS A general two-port network is shown in Figure 7.1. Figure 7.1 General Two-Port Network I2 V2 I1 and V1 are input current and voltage respectively. Also 12 and V2 are output current and voltage respectively. It is assumed that the linear two-port circuit contains no independent sources of energy and that the circuit is initially at rest no stored energy . Furthermore any controlled sources within the linear two-port circuit cannot depend on variables that are outside the circuit. 7.1.1 z-parameters A two-port network can be described by z-parameters as V1 z1111 Z1212 7.1 V2 z2111 z2212 7.2 In matrix form the above equation can be rewritten as 1999 CRC Press LLC V z11 Z12 11 V _ _Z21 Z22 _ 1 U 2 J 7.3 The z-parameter can be found as follows Z11 y I I2 o 7.4 11 Z12 l1 0 7.5 1 2 Z21 112 o 7.6 11 Z22 111 0 7.7 12 The z-parameters are also called open-circuit impedance parameters since they are obtained as a ratio of voltage and current and the parameters are obtained by open-circuiting port 2 12 0 or portl 11 0 . The following example shows a technique for finding the z-parameters of a simple circuit. Example 7.1 For the T-network shown in Figure 7.2 find the z-parameters. Z2 Z 11 Figure 7.2 T-Network 2 1999 CRC Press .