Đang chuẩn bị liên kết để tải về tài liệu:
Increase of productivity in assembly and machining lines of clutch servo assembly line

The objective of this paper is to improve the productivity of the various assembly & machining lines. Productivity can be increased by reducing the total cycle time of the assembly lines of clutch servo assembly lines, finding the non-value added time, reducing the bottle neck time, line balancing in each assembly station, by supplying proper material flow and by improving the line layout | Increase of productivity in assembly and machining lines of clutch servo assembly line International Journal of Management IJM Volume 11 Issue 5 May 2020 pp. 454-464 Article ID IJM_11_05_043 Available online at http www.iaeme.com ijm issues.asp JType IJM amp VType 11 amp IType 5 Journal Impact Factor 2020 10.1471 Calculated by GISI www.jifactor.com ISSN Print 0976-6502 and ISSN Online 0976-6510 DOI 10.34218 IJM.11.5.2020.043 IAEME Publication Scopus Indexed INCREASE OF PRODUCTIVITY IN ASSEMBLY AND MACHINING LINES OF CLUTCH SERVO ASSEMBLY LINE S. Karthik Assistant Professor Department of Mechanical Engineering Veltech Rangarajan Dr.Sagunthala R amp D Institute of Science and Technology Chennai India ABSTRACT Every industry face the challenges of improving productivity in order to remain successful in a highly competitive environment. Every year input costs goes higher and industry is responsible to provide the better products at lower costs to the end customer by improving the efficiency of the plant. The objective of this paper is to improve the productivity of the various assembly amp machining lines. Productivity can be increased by reducing the total cycle time of the assembly lines of clutch servo assembly lines finding the non-value added time reducing the bottle neck time line balancing in each assembly station by supplying proper material flow and by improving the line layout Key words clutch servo Line balancing Material flow Cite this Article S. Karthik Increase of Productivity in Assembly and Machining Lines of Clutch Servo Assembly Line. International Journal of Management 11 5 2020 pp. 454-464. http www.iaeme.com IJM issues.asp JType IJM amp VType 11 amp IType 5 1. INTRODUCTION Productivity is defined as a total output per one unit of a total input. In control management productivity is a measure of how efficiently a process runs and how effectively it uses resources .In a simple words productivity is the ratio between output and input. It is a .