Đang chuẩn bị liên kết để tải về tài liệu:
Microsoft Press transitioning your mcsa mcse to windows server 2008 2009 phần 10

Ví dụ, dirquota.exe bao gồm một tham số xuất khẩu mẫu để viết các thiết lập mẫu cho phép vào một tập tin XML, nhập khẩu mẫu một tham số để nhập khẩu các thiết lập mẫu từ các tập tin XML. Thêm / từ xa: ComputerName tham số lệnh dirquota mẫu nhập khẩu nhập khẩu các mẫu từ các tập tin XML trên máy tính | C. Incorrect The netsh interface ipv4 set address name Local Area Connection static 192.168.10.1 255.255.255.0 192.168.10.10 command would set the IPv4 address to 192.168.10.1 and the default gateway to 192.168.10.10. D. Incorrect You must put spaces between the settings not commas. This command would return an Invalid IP Address error. Lesson 2 1. Correct Answer B A. Incorrect You use the start w ocsetup DHCPServerCore command to install the DHCP server role on a Server Core installation of Windows Server 2008. B. Correct The sc config dhcpserver start auto command configures the DHCP Server service to start automatically on a Server Core installation of Windows Server 2008 when Windows starts. C. Incorrect The servermanagercmd -install dhcp command installs the DHCP server role on a full installation of Windows Server 2008. You cannot use this command on a Server Core installation. D. Incorrect The net start DHCPServer command starts the DHCP Server service after it is already installed. 2. Correct Answer A A. Correct This is 80 percent of the available addresses on VLAN1 plus 20 percent of the available addresses on VLAN2. B. Incorrect This is 80 percent of the available addresses on VLAN2 plus 20 percent of the available addresses on VLAN1. These are the scopes that should be configured on VLAN2. C. Incorrect This is 50 percent of the available addresses on VLAN1 plus 50 percent of the available addresses on VLAN2. This solution does not follow the 80 20 rule. D. Incorrect These scopes overlap. 3. Correct Answer C A. Incorrect You can configure only one contiguous address range per scope. B. Incorrect Configuring a scope option that assigns the DNS server address to clients does not prevent the scope from leasing out an address that is the same as the one statically configured on the DNS server. C. Correct Creating an exclusion for the DNS server address is the simplest way to solve the problem. When you configure the exclusion the DHCP server will not lease .