Đang chuẩn bị liên kết để tải về tài liệu:
configuring and troubleshooting windows xp professional phần 4

Để có những câu hỏi của bạn về chương này trả lời của tác giả, trình duyệt www.syngress.com / giải pháp và click vào hình thức "Ask Tác giả".Q: Các khu vực Quick Launch mà từ đó tôi có thể bấm vào một nút và nhận được trở lại máy tính để bàn đã biến mất. Làm thế nào để cho nó trở lại? | 212 Chapter 5 Working with System Tools 9. Change the Initial size and Maximum size to at least the recommended size. Be sure you have this size available as one piece of contiguous free space or it is likely that it will be fragmented right from the start. By choosing an initial size that is significant you can postpone the moment the paging file starts to fragment. Depending on the initial size you can set the maximum size. As you move the initial size up you can use the same maximum size. A large initial size is recommended to prevent fragmentation in the long haul and because disks are so large nowadays you should be able to afford it. 10. Click Set. 11. Select the volume for which you previously created the temporary paging file and set the Initial size and Maximum size to zero and click Set. 12. Close all windows and reboot the system. After the system is restarted again you may decide to remove the temporary paging file altogether by selecting the No paging file option for that volume in the Virtual Memory dialog box. Preventing the defragmentation of the MFT is trickier because it is fully controlled by the Windows XP system.Without going into too much detail it is important to know that the size of the MFT and the MFT Zone are both based on the size of the volume. The MFT size is calculated as the NTFS volume is created while the MFT Zone size also based on the volume size is calculated during the mounting of the volume and reserved for the MFT growth. Note that the system will always claim the same piece of storage on the volume for the MFT Zone because it happens as part of the mounting process and therefore is the first process that has access to the volume. However if during the uptime the system runs out of MFT Zone space it has to claim another piece of volume storage to create a new MFT Zone hence MFT fragmentation.The only way to prevent this is claiming as much MFT Zone as possible. You can control the size that is claimed for the MFT Zone through