Tham khảo tài liệu 'lubrication fundamentals 2011 part 15', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | transfer pump will not suck air that might cause binding or locking. Pump pressures should be checked periodically and lines should be inspected for leaks or damage. Again as stated earlier any industrial plant lubrication program should meet federal state and local codes and requirements which includes health and safety factors as well as addressing environmental issues. BIBLIOGRAPHY Mobil Technical Bulletin Handling Storing and Dispensing Industrial Lubricants Technical and Regulatory References National Fire Prevention Association NFPA 30 Occupational Safety and Health Administration OSHA 29 CFR. Copyright 2001 by Exxon Mobil Corporation. All Rights Reserved. 19 In-Plant Handling and Purification for Lubricant Conservation Conservation of natural resources and the protection of the environment have become common goals in society today. Depending on current plant practices these goals can be accomplished generally with minimal cost impact in the areas of lubricant use and disposal. Control of lubricants inside the plant to prevent the generation of oily wastes is just one such operation. Any lubricant that becomes a waste increases operating costs from the standpoint of material purchases waste disposal and environmental protection issues. A plant lubricant that becomes a waste product may require reclamation or disposal under proper control to prevent pollution for the following reasons. 1. Contamination with water foreign matter dust process materials or wear metals from the lubricated equipment or dilution 2. Degradation during use due to depletion of additives increases in total acid number formation of oxidation products change in viscosity or loss of lubricity 3. Escape from system through leaks spills line breakage faulty gaskets or excessive foaming overlubrication in all-loss systems carry-off on products in process One key to preventing any lubricant from becoming a waste product lies in the selection storage and handling of these products in the plant
