Tham khảo tài liệu 'advances in solid state part 6', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | 8 Continuous-Time Analog Filtering Design Strategies and Programmability in CMOS Technologies for VHF Applications Aranzazu Otín Santiago Celma and Concepcion Aldea Group of Electronic Design Aragón Institute for Engineering Research I3A . Zaragoza University Zaragoza. Spain 1. Introduction The evolution of wireless applications the performance as well as the number of users has undergone explosive growth in the last years resulting in an increasing demand for smaller low-cost wireless transceivers with low power consumption. In order to meet this demand continuous development must take place both in CMOS technology and in RF electronics the goal of which should be to achieve a fully-integrated single-chip receiver in a low-cost CMOS process. This demand for complex read channel and multi-standard receiver ICs calls for the design and implementation of one category of analog interface chips as continuoustime CT filters suitable for high speed with variable bandwidths over a wide frequency range preferably using the Gm-C approach rather than other existing solutions. Filters based on the Gm-C technique were used quite early on with bipolar technology and they have now become the dominant option to implement monolithic filters for very high frequency. The basic building block of a Gm-C filter is the integrator which involves the use of transconductors and capacitors only and whose structure is therefore simpler than others such as operational amplifiers. The simplicity of the transconductor coupled with the openloop operation which does not involve any complex frequency compensation schemes point to this cell as the basic active element to be considered and the best option to operate in a VHF range with low supply voltages. Io _ v gm Io gmVin in Fig. 1. Ideal transconductor Vin to Io converter of transconductance gm conversion factor . All the benefits of the Gm-C approach lie in the ideal behaviour of the transconductor. Nevertheless its use as the basic element in
