Tuyển tập báo cáo các nghiên cứu khoa học quốc tế ngành hóa học dành cho các bạn yêu hóa học tham khảo đề tài: A Sigma-Delta ADC with Decimation and Gain Control Function for a Bluetooth Receiver in 130 nm Digital CMOS | Hindawi Publishing Corporation EURASIP Journal on Wireless Communications and Networking Volume 2006 Article ID 71249 Pages 1-8 DOI WCN 2006 71249 A Sigma-Delta ADC with Decimation and Gain Control Function for a Bluetooth Receiver in 130 nm Digital CMOS Jinseok Koh Gabriel Gomez Khurram Muhammad R. Bogdan Staszewski and Baher Haroun Wireless Analog Technology Center Texas Instruments Inc. Dallas TX 75243 USA Received 25 October 2005 Revised 15 April 2006 Accepted 18 April 2006 We present a discrete-time second-order multibit sigma-delta ADC that filters and decimates by two the input data samples. At the same time it provides gain control function in its input sampling stage. A 4-tap FIR switched capacitor SC architecture was chosen for antialiasing filtering. The decimation-by-two function is realized using divided-by-two clock signals in the antialiasing filter. Antialiasing gain control and sampling functions are merged in the sampling network using SC techniques. This compact architecture allows operating the preceding blocks at twice the ADC s clock frequency thus improving the noise performance of the wireless receiver channel and relaxing settling requirements of the analog building blocks. The presented approach has been validated and incorporated in a commercial single-chip Bluetooth radio realized in a V 130 nm digital CMOS process. The measured antialiasing filtering shows better than 75 dB suppression at the folding frequency band edge. A 67 dB dynamic range was measured with a sampling frequency of MHz. Copyright 2006 Jinseok Koh et al. This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use distribution and reproduction in any medium provided the original work is properly cited. 1. INTRODUCTION Discrete-time analog signal processing approaches for Bluetooth wireless receivers have been proposed and successfully implemented 1 2 . These receivers employ a discrete-time .
