Considering the high probability of the existence of the postshock excitable tunnel even for above-DFT shocks, defibrillation success may be explained by the fact that initiating PAs, originating within the wall, cannot find an excitable exit onto the epicardium and die out in the mid-myocardium. Obtaining such insight into the mechanisms of defibrillation would have been impossible with the use of experimentation alone. | SIEMENS Introduction 1 Turning On Reference-Point Approach 2 Setting Up 3 SINUMERIK 802D SINUMERIK 802D base line Manually Controlled Mode 4 Programming and Operating Turning Automatic Mode 5 Part Programming 6 System 7 Programming 8 Cycles 9 Valid for Control system Software version SINUMERIK 802D 2 SINUMERIK 802D base line 1 08 05 Edition Safety information This Manual contains information which you should carefully observe to ensure your own personal safety and the prevention of material damage. The notices are highlighted by a warning triangle and depending on the degree of hazard represented as shown below Danger indicates that death or severe personal injury will result if proper precautions are not taken. Warning indicates that death or severe personal injury can result if proper precautions are not taken. Caution with a warning triangle indicates that minor personal injury can result if proper precautions are not taken. Caution without a warning triangle means that material damage can occur if the appropriate precautions are not taken. Attention indicates that an undesired event or status can occur if the appropriate note is not observed. If several hazards of different degrees occur the hazard with the highest degree must always be given preference. If a warning note with a warning triangle warns of personal injury the same warning note can also contain a warning of material damage. Qualified personnel Start-up and operation of the device equipment system in question must only be performed using this documentation. The start-up and operation of a device system must only be performed by qualified personnel. Qualified personnel as referred to in the safety guidelines in this documentation are those who are authorized to start up earth and label units systems and circuits in accordance with the relevant safety standards. Proper use Please note the following Warning The device may only be used for the applications described in the Catalog and only in .
