Tham khảo tài liệu 'cơ bản thiết kế asembly', công nghệ thông tin, kỹ thuật lập trình phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Chapter Seven BASIC ASSEMBLY DESIGN 79 There is a number of ways to enter ASSEMBLY DESIGN mode. Any ONE way will do it. Click here Click here Click here 80 Assembling your individual parts into one assembly is very simple and user friendly in Catia. The first thing to do is gather up your parts. Here we have a simple plate with a hole in the middle. 81 We are going to take this one inch diameter rod and insert it through the hole in our plate using the ASSEMBLY DESIGN features. Ensure that you have saved your parts to a convenient location for quick access later. 82 Now you are in Assembly mode. Notice on the beginning of the new specification tree it says product. Your product will be the assembly of the parts you made. 83 This is your PRODUCT STRUCTURE toolbar. It is how you will bring in your parts you have made and saved. Single click “Product” in your specification tree, and then click INSERT COMPONENT. From here you can instead click NEW PART and draw one as needed. Other options are also here self-evident by their names. New Component New Part Insert Component Manage Representations Replace Component Fast Multi Instantination 84 Here is the first part brought in using Insert Component. It’s existence is reflected in the specification tree. Now we will bring in the next part the same way. 85 Both parts are now in the Assembly environment, and both are reflected in the tree. They enter the environment in approximately the same orientation that they were saved. You can now move and orient them the way you wish. Catia will help you here. 86 This is your CONSTRAINTS toolbar for use in assemblies. They are also named in a self-explanatory manner. COINCIDENCE and CONTACT constraints will be used most. Coincidence Contact Offset Angle Fix components Fix together Quick constraints ReUse pattern 87 The first skill you will want to learn here is how to manually move parts around relative to one another. Pick the face of the Plate and prepare to move it. 88 Grab the COMPASS from the top right corner of your screen. Put your cursor on the red square of the compass and click and drag it to the highlighted part. 89 Once on your part, the compass becomes green when active. As you move your cursor over it, different parts will turn orange. The orange part highlighted represents the way the part will rotate. Picking the “flagpole” will move the part in a linear motion. flagpole 90 Once you have moved the parts relative to one another, since we are locating round parts we will use COINCIDENCE RESTRAINT. Choose this and then pick the centerlines of the two parts involved. Centerline chosen 91 As you pick the second centerline, Catia will automatically constrain them. If Catia does not immediately line them up, click the UPDATE icon. 92 Here are the two parts with a coincidence constraint applied , ready to be put together. We can do this manually. 93 Pick the face of the rod and put the compass there. Grab the “flagpole” and slide the rod into the hole roughly half way. We will constrain it exactly in a moment. 94 Here is your part ready for the final constraint. We will constrain it so that half the rod sticks out of either side of the plate. 95 Choose OFFSET constraint and then pick the plate face and the rod face. In the dialog box that pops up, enter the offset. Here we will use inches. 96 Finally, here is your part ready to be DRAFTED and put into production. Notice all the constraints are reflected in the specification tree. 97
