Tham khảo tài liệu 'car rim – part and assembly photo rendering', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | NUT ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN Car Rim - Part and Assembly Photo Rendering Pro ENGINEER Wildfire Dr. Herli Surjanhata Create a part named car_rim with three default datum planes and default coordinate system. CREATE A REVOLVED PROTRUSION AS A BASE FEATURE Create a revolved protrusion on the FRONT datum plane and pick TOP datum plane as the top reference. The dimensions of the section to be revolved are shown in Figure below. Make sure the dimension and 16 are diametrical dimension. 1 The resulted feature is shown below 2 CREATE A REVOLVED CUT The dimensions are shown below. CREATE AN INSIDE CUT ON THE TOP PART OF THE RIM The cut is made by revolving the rectangular section shown below.
