Tham khảo tài liệu 'auxiliary views of control bracket', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN AUXILIARY VIEWS OF CONTROL BRACKET Pro ENGINEER Wildfire Dr. Herli Surjanhata PREPARING THE CONTROL BRACKET FOR DETAILED DRAWING Create a working directory and download the zip file of control bracket. Open . Create a new datum plane DTM4 - using that pass through the axis A 1 of the hole and perpendicular to the top inclined surface of control bracket - see figure below. 1 Create another datum plane DTM5 - using that pass through the axis A 8 of the hole and perpendicular to the right inclined surface of control bracket - see figure below. 2 Both datum planes will be used for creating partial auxiliary section views. CREATE A DETAILED DRAWING OF CONTROL BRACKET The previously C-size of drawing template will be used for detailed drawing of shaft. IMPORTANT Be sure to copy the drawing template file you intend to use in your working directory. In this case copy to your working directory.
