Nghệ thuật xếp hình Nhật Bản:heartring_2

Nghệ thuật xếp hình: heartring_2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Heart Ring Copyright 1998-99 Stephen Hecht. All Rights Reserved A dollar bill makes a ring with a heart measuring 35mm across and 38 mm tall. For first attempt begin with a 3x7 rectangle larger than a dollar bill. 3. Valley down at one-fourth. 1. Either side up I think it looks better if you start with the black side up. Crease at eights horizontally but not too sharp in the middle. 2. Valley in half vertically. Then add 3 more alternating creases on each side at one-eight-width distance. 4. Crease sharply where shown. 5. Pleat sinking on creases from previous step. 6. Like so. Pleat and unfold. Do valley-fold first then align mountain-fold on edge A. 7. Pleat and sink as in step 5 but sink the long top edge too. Swinging the little flap over first helps. 8. Like so. Repeat steps 4-7 on left end of bill. 9. Closed sink tucking behind the central band. Heart Ring continued Copyright 1998-99 Stephen Hecht. All Rights Reserved OPTIONAL -- thinner band 12. Closed sink. 10. Fold the upper flap in half. Note the fudging that is necessary within the sunken zone. Repeat on the left side. Remaining non-optional diagrams don t reflect this step. 11. Swing middle two flaps outward. 13. Reverse folds. They go on top of the sunken trapezoid from the previous step. 14. Pull down center swinging the sides in. 15. Tuck under. 16. Swing over. 17. Squash. 18. Make the squash sharp only where indicated. Swing top back down. Heart Ring continued Copyright 1998-99 Stephen Hecht. All Rights Reserved 19. Swing back over which lifts up the lower portion. The x-ray line is a hidden valley-fold squash . 20. First squash where indicated. Then flatten remaining edges. flatten squash upwards l6-20 21. Unfold 16-20. Repeat 16-20 on left end. Then reform both sides together and disentangle the bottom to form a water-bomb base. OPTIONAL -- thinner band OPTIONAL 22. Open sink long edge. Partially unfold to sink but be careful at the top. Repeat at left. 23. Wrap around top layer to the inside. .