This guide is intended to help you quickly get your CSS 11050, CSS 11150, and CSS 11800 content services switches (hereinafter referred to as the CSS) installed and into operation. It provides you with instructions for installing, cabling, booting, and configuring the CSS. Information in this guide applies to all CSSs except where noted. This guide is intended for the following trained and qualified service personnel who are responsible for installing and operating the CSS: | Cisco Content Services Switch Getting Started Guide Software Version December 2000 Corporate Headquarters Cisco Systems Inc. 170 West Tasman Drive San Jose CA 95134-1706 USA http Tel 408 526-4000 800 553-NETS 6387 Fax 408 526-4100 Text Part Number 78-11766-01 THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS INFORMATION AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS. THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY. The following information is for FCC compliance of Class A devices This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates uses and can radiate radio-frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case users will be required to correct the interference at their own expense. The following information is for FCC compliance of Class B devices The equipment described in this manual generates and may radiate radio-frequency energy. If it is not installed in accordance with Cisco s installation instructions it may cause interference with radio and television reception. This equipment has been tested and found to comply with
