This standard is issued under the fixed designation C 110; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. | Designation C 110 00 Standard Test Methods for Physical Testing of Quicklime Hydrated Lime and Limestone1 This standard is issued under the fixed ches ii r i tion c 110 the number immediately following the designation indicates the year of original adoption or in the case of revision the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope These test methods cover physical testing of quicklime and hydrated lime and of limestone not otherwise covered in ASTM Note 1 Quicklime and hydraeed lime have a high fffirnty oor moistuse and carbon dioxide. Caution should be taken to protect both hydrated and quicklime during sampling storage and testing see Practice C 50 . The test procedures appear in the following order Section Air Entrainment 13 Apparent Loose Density of Hydrated Lime Pulverized Quicklime and Limestone 16 Apparent Packed Density of Hydrated Lime Pulverized Quicklime and Limestone 17 Autoclave Expansion of Hydrated Lime 8 Dry Brightness of Pulverized Limestone 15 Dry Screening by Air Jet Sieve 19 Fineness of Pulverized Quicklime and Hydrated Lime by Air Permeability 18 Limestone Grindability 20 Particle Size of Pulverized Limestone 14 Plasticity of Lime Putty 7 Popping and Pitting of Hydrated Lime 9 Residue and Sieve Analysis 5 Settling Rate of Hydrated Lime 11 Slaking Rate of Quicklime 12 Speci c Gravity of Hydrated Lime Products 21 Standard Consistency of Lime Putty 6 Water Retention of Hydrated Lime 10 Wet Sieve Analysis of Agricultural Liming Materials 22 The values stated in SI units are to be regarded as the standard. This standard does not purport to address all of the safety concerns if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health
