This standard is issued under the fixed designation C 183; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. | Designation C 183 97 Standard Practice for Sampling and the Amount of Testing of Hydraulic Cement1 This standard is issued under the fixed d ii r atic n c 183 the number immediately following the designation indicates the year of original adoption or in the case of revision the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope This practice covers procedures for sampling and for the amount of testing of hydraulic cement after it has been manufactured and is ready to be offered for sale. The values stated in SI units are to be regarded as the standard. The inch-pound units in parentheses are for information purposes only. A ton as used in this practice is 907 kg 2000 lb . Values in SI units shall be obtained by measurement in SI units or by appropriate conversion using the Rules for Conversion and Rounding given in Standard IEEE ASTM SI 10 of measurement made in other units. This standard does not purport to address all of the safety concerns if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 2. Referenced Documents ASTM Standards C 91 Speci cation for Masonry Cement2 C 109 Test Method for Compressive Strength of Hydraulic Cement Mortars Using 2-in. or 50-mm Cube Specimens 2 C 114 Test Methods for Chemical Analysis of Hydraulic Cement2 C 115 Test Method for Fineness of Portland Cement by the Turbidimeter2 C 150 Specification for Portland Cement2 C 151 Test Method for Autoclave Expansion of Portland Cement2 C 157 Test Method for Length Change of Hardened Hydraulic-Cement Mortar and Concrete3 C 185 Test Method for Air Content of Hydraulic Cement Mortar2 C 186 Test .
