This standard is issued under the fixed designation C 184; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. | Designation C 184 - 94e1 Standard Test Method for Fineness of Hydraulic Cement by the 150-pm No. 100 and 75-pm No. 200 Sieves1 This standard is issued under the fixed 40 1136011 c 184 the number immediately fc llc Wr ig the designation indicates the year of original adoption or in the case of revision the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. e1 Note The calculation n was corrected in Febi tiary 1996. 1. Scope This test method covers determination of the fineness of hydraulic cement by means of the 150-pm No. 100 and 75--m No. 200 sieves. This standard does not purport to address the safety concerns if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The values given in SI units are to be regarded as the standard. 2. Referenced Documents ASTM Standards C 114 Test Methods for Chemical Analysis of Hydraulic Cement2 E 11 Specificalion for Wire-Cloth Sieves for T i iilmg Purr 3 poses3 3. Apparatus Sieves Stirndard 150--mi No. 100 or 75--1111 No. 200 sieves conforming to the requirements of Specificalion E 11. iire cloth for standard sieves for cement shall be woven not twilled from brass bronze or other suitable wire and mounted without distortion on a frame about 50 mm 2 in. below the top of the frame. The joint between the cloth and frame shall be smoothly lled with solder to prevent lodging of the cement. The sieve frame shall be circular 203 mm 8 in. in diameter and provided with a pan and cover. Balance The anal vOcal t ilkm c rued in fineness determinations shall conform to the requirements of of Test Methods C 114. Weights The weighss used m fineness deiem linaiions shall conform to the requirements of of Test
