Tài liệu tham khảo về cách xếp Chim se sẻ. | Sparrow By Perry Bailey Copyright 2000 2. Fold the sides up in to a rabbits ear or make the fish base which ever you prefer. 3. Reverse fold the end down from the center So that it is center in the middle of the model. 4. Reverse fold the flap part of the way back up. 5. The model should look like this at this point. Now with out creasing the top layers open up the bottom of the model. 7. It should have at least a vague resemblance to this if it does then fold the bottom of the model back down. 6. Swivel fold the sides into the center of the model to flare the tail. 8. If all has gone well it should look like this if it does then go on to the next step. X-ray view of inside of tail if the top layers were removed. 9. Mountain fold the trailing edge of body back into it s self to do this you probably will need to make a small i swivel fold in the tail. 1 2 10. The swivel fold inside would look like this. 1 2 14. Reverse fold the head forward. 11. At the halfway mark on the top edge reverse fold the front of the model up. 13. Sink the center layer in and then fold the outer layers into the inner sink. 12. Now release the trapped layer of paper on each side and fold it forward. If you were to make this with regular kami color one side white the other you would be making a partial color change. 15. Now pull out the trapped layers inside of the head to make it larger. I 16. Pleat the beak in a bit. 17. Fold the flaps forward they are about to become wings 18. Fold the flaps back at a jaunty angle for the wings 20. Tuck in a little of the breast to improve the lines. 19. These are the finishing touches. Fold the back of the head in to the body then sink the top of the head and the next spot down in the front of the head the rest of the head can be managed just fine with mountain folds. Finally we are done 21. Mountain fold a little bit underneath so it will stand .
