Tài liệu tham khảo về cách xếp Mèo Picachu. | Spenjurmunni Designed by Robert J. Lang Copyright 1999. All Rights Reserved. Any resemblance between this origami design and a character from any irritating-sound-producing videogame overpriced trading card or mind-numbing poorly-animated TV show is purely coincidental. 3. Fold the bottom point up so that its edge hits the right corner. 4. Fold the horizontal edge down so that it aligns with the folded edge. 5. Fold the edge back up so that it aligns with a folded edge. 6. Unfold to step 3. 10. Fold the two flaps down and flatten the model firmly. 7. Repeat steps 3-6 on the right. 8. Use the creases you just made to form three nested 9. Pinch the flap in half and swing it over to the right. rabbit ear folds. 11. Bring the long flap to the front. This flap will be the tail. 12. Fold the top flap down. 13. Fold the flap back up. Note that the crease hits the centerline at the same point as the tail 14. Fold the top flap down so that its tip aligns with a hidden horizontal crease. 16. Swivel-fold the edges. 15. Bring the raw edges to the front on both left and right. 17. Fold the flaps out to the sides. 18. Fold the top edge down along a crease that runs from corner to corner. 19. Pleat the ears at the top of the model. 20. Mountain-fold four flaps to the rear. 21. Valley-fold the corners. tail. Pleat the tail like a lightning bolt. 23. Turn the model over. 24. Finished model. Color on a face as shown in the next figure. 25. Finished Spenjurmunni taking a peek at .
