ADC has developed the OMX600® optical distribution frame to meet today‘s network demands. Designed with total front access, the OMX600 has five right-hand and five left-hand mounting positions and can be installed back-to-back or against a wall to save valuable office floor space. This high-density frame terminates and splices up to 576 fibers in a 600 mm x 300 mm (" x ") footprint. | OMX600 Optical Distribution Frame Optical Distribution Frames Things to Consider When Fiber Distributing Preterminated Fiber Termination Panels with Preterminated Fiber Termination Panels with Multifiber Adapter-Only Fiber Termination Splice Value-Added Module VAM Jumper Storage Interbay Management Frame Installation End Splice Splice Cable Standard Cross-Connect Patch Cord Ordering Information for Patch Cords and 1-952-938-8080 1-800-366-3891 OMX600 Optical Distribution Frame Introduction Cabinet Solutions ADC has developed the OMX600 optical distribution frame to meet today s network demands. Designed with total front access the OMX600 has five right-hand and five left-hand mounting positions and can be installed back-to-back or against a wall to save valuable office floor space. This high-density frame terminates and splices up to 576 fibers in a 600 mm x 300 mm x footprint. Termination Panel The OMX600 termination panels are available with 72 96 or 144 with LC adapters. These panels can be ordered with adapters only or preterminated with either intrafacility IFC outside plant OSP cables or pigtails for ease of installation. The panels are available with industry-standard connector adapter styles. Splice Panel The OMX600 splice panel provides protection and a mounting location for ADC s round splice trays. Each splice panel is two mounting positions tall and holds 24 splice trays. Each splice tray can house up to 24 splices. I Storage Panel The storage panel enables storage of fiber-optic jumper slack within an OMX600 frame. Each jumper storage module is one module position tall. The interbay management panel provides off-frame storage of jumper slack. ADC recommends the use of mm patch cords to maximize the cable management potential. .
