Calculating the subnet addressing for the lab using the VLSM technique and note all information. | ĐỀ THI SKILL CCNA1 CCNA1 SKILL BASED EXAMINATION Duration: 80 minuten Configuration requirements: (8 marks) 1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology. 2. In each LAN, configure the second usable host address for PC1 and the last usable host address for PC2. 3. Perform Basic Router Configurations all Routers. 4. Enable routing on R1, R2, R3 and R4 by using the static routing protocol. Challenge questions: (2 marks) 1. How many bits need to be borrowed if the Classfull subneting technique is used ? __4 bit__ Subnet 1: ---> Subnet 2: ---> Subnet 3: ---> 2. How many addresses for hosts will the network provide? A. 510 B. 512 C. 1022 C. 1024 D. 2046 E. 2048 CCNA1 SKILL BASED EXAMINATION Duration: 80 minuten Configuration requirements: (8 marks) 1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology. 2. In each LAN, configure the second usable host address for PC1 and the last usable host address for PC2. 3. Perform Basic Router Configurations all Routers. 4. Enable routing on R1, R2, R3 and R4 by using the static routing protocol. Challenge questions: (2 marks) 1. How many bits need to be borrowed if the Classfull subneting technique is used ? __4 bit__ Subnet 1: ---> Subnet 2: ---> Subnet 3: ---> 2. How many addresses for hosts will the network provide? A. 510 B. 512 C. 1022 D. 1024 E. 2046 F. 2048 CCNA1 SKILL BASED EXAMINATION Duration: 80 minutes Configuration requirements: (8 marks) 1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology. 2. In each LAN, configure the second usable host address for PC1 and the last usable host address for PC2. 3. Perform Basic Router Configurations all Routers. 4. Enable routing on R1, R2, R3 and R4 by using the static routing protocol. Challenge questions: (2 marks) 1. How many bits need to be borrowed if the Classfull subneting technique is used ? __4 bit__ Subnet 1: ---> Subnet 2: ---> Subnet 3: ---> 2. How many addresses for hosts will the network provide? A. 510 B. 512 C. 1022 D. 1024 E. 2046 F. 2048 CCNA1 SKILL BASED EXAMINATION Duration: 75 minutes I. CONFIGURATION REQUIREMENTS: (6 MARKS) 1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology. 2. In each LAN, configure the second usable host address for PC1 and the last usable host address for PC2. 3. Enable routing on R1, R2, and R3 by using the static routing protocol II. CHALLENGE QUESTIONS: (4 MARKS) 1. How many subnets are there in the above diagram ?.4 2. How many bits need to be borrowed if the classfull subneting technique is used ?.11 bit. 3. What kind of router will be the router provide the clock rate for another? . 4. Is it possible if the serial connection between R1 and R2 is replaced by the ethernet LAN connection?
