Each PIX Firewall has two or more physical network interfaces. Configure each interface with an IP address, network speed, maximum transmission unit (MTU) size, and so on. Refer to the interface command page within the Cisco PIX Firewall Command Reference for complete information on the interface command. Table A-1 provides a form for entering PIX Firewall network interface information. | APPENDIX Firewall Configuration Forms Installing PIX Firewall requires a thorough knowledge of your company s network topology and security policy. To get the PIX Firewall running immediately fill in the information in Table A-1 to Table A-4 and proceed to Chapter 2 Establishing Connectivity. To configure the PIX Firewall for specific types of network traffic fill in the information in Table A-5 through Table A-8 and follow the instructions in Chapter 3 Controlling Network Access and Use. Information may not appear in the same order in the forms as it does in a configuration listing. The Cisco PIX Firewall Command Reference provides the complete syntax for all PIX Firewall commands. This appendix includes the following sections PIX Firewall Network Interface Information Routing Information Network Address Translation Static Address Translation Inbound Access Control Outbound Access Control Authentication and Authorization For specific information about your network environment contact your network administrator. Cisco PIX Firewall and VPN Configuration Guide I 78-13943-01 A-1 Appendix A Firewall Configuration Forms PIX Firewall Network Interface Information PIX Firewall Network Interface Information Each PIX Firewall has two or more physical network interfaces. Configure each interface with an IP address network speed maximum transmission unit MTU size and so on. Refer to the interface command page within the Cisco PIX Firewall Command Reference for complete information on the interface command. Table A-1 provides a form for entering PIX Firewall network interface information. Table A-1 PIX Firewall Network Interface Information Interface Name Interface Type Hardware ID Interface IP Address Interface Speed MTU Size Interface Security Level Outside 0 Inside 100 Routing Information Table A-2 provides a form for entering route information. Refer to the Cisco PIX Firewall Command Reference for complete information on the route command and the rip command. The router IP
