Lab 6.1.6 Configuring Static Routes

Tham khảo tài liệu 'lab configuring static routes', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Cisco SrsTEMS Lab Configuring Static Routes Router ID Router Name Enable secret password EnablefVTY and Console passwords Routing protocol RIP network statements Rouler 1 GAD class cisco none none Rouler 2 BHM claaa cisco none none Router ID IP host name Fast Ethernet 0 address Interface type Serial 0 Serial 0 address Interface type Serial 1 Serial 1 address Subnet mask all addresses Rouler 1 GAD DOE 192 16 15 1 NA No address 256 255 256 0 Rouler 2 BHM DTE NA No add re E E . Ũ Etraiqhr-thmugh ohBIe Serial cable Console Rollover Crossover cable Objective Configure static routes between routers to allow data transfer between routers without the use of dynamic routing protocols. Background Preparation Setup a network similar to the one in the previous diagram. Any router that meets the interface requirements may be used. Possible routers include 800 1600 1700 2500 2600 routers or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. Step 1 Configure both routers a. Enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. If there are any difficulties refer to 1 - 6 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. the Configuring router passwords lab. Configure interfaces and IP host tables. If there are any .