Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed in the above diagram, such as 800, 1600, 1700, 2500, and 2600 routers, or a combination, may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically. | ClíCf SíịlE U9 Lab Configuring RIP Router 1 Router 2 Straight-through cable Serial cable Rollover console cable Crossover cable Router Designation Router Name FastEthernet 0 Address Interface type Serial 0 Address Subnet mask for both interfaces Enable secret password Enable VTY Console passwords Router 1 GAD DCE class cisco Router 2 BHM DTE class cisco Objective Setup an IP addressing scheme using class B networks. Configure the RIP dynamic routing protocol on routers. Background Preparation Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed in the above diagram such as 800 1600 1700 2500 and 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. Step 1 Configure the routers a. From the global configuration mode configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. If there is a problem doing this refer to the configuring router passwords lab. Next configure the interfaces according to the chart. Refer to the Configuring Host Tables lab for assistance. 1 - 5 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Step 2 Check the routing table entries a. Using the command show ip route view the IP routing table for GAD. GAD show ip route .
