Tham khảo tài liệu 'lab unequal cost load balancing with igrp', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | ClíCf SíịlE U9 Lab Unequal Cost Load Balancing with IGRP Straight-through cable Serial cable Rollover console cable Crossover cable Router designation Router name Enable secret password Enable VTY and Console passwords Routing protocol RIP network statements Router 1 MAD class cisco IGRP Router 2 MIL class cisco IGRP Router designation IP host name FastEthernet 0 address Interface type Serial 0 Serial 0 address Interface type Serial 1 Serial 1 address Subnet mask all addresses Router 1 MIL DCE DCE Router 2 MAD DTE DTE Objective Observe unequal-cost load balancing. Tune IGRP networks by using advanced debug commands. Background Preparation In this lab a default route will be configured and RIP used to propagate this default information to other routers. When this configuration is working properly the network will be migrated from RIP to IGRP and default routing will be configured to work with that protocol as well. Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800 1600 1700 2500 and 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the 1 - 6 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all .
