Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram, such as. 800, 1600, 1700, 2500, and 2600 routers, or a combination, may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically. | ClíCf SíịlE U9 Lab Last Route Update Router 1 Router 2 Straight-through cable Serial cable Rollover console cable Crossover cable Router Designation Router Name FastEthernet 0 Address Interface type Serial 0 Address Subnet mask for both interfaces Enable secret password Enable VTY Console passwords Router 1 GAD DCE class cisco Router 2 BHM DTE class cisco Objective Gather information about routing updates and routing protocols. Background Preparation Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram such as. 800 1600 1700 2500 and 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. Step 1 Configure the routers a. On the routers enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. If there is a problem doing this refer to the Configuring Router Passwords lab. Next configure the interfaces according to the chart. If there is a problem doing this refer to the Configuring Host Tables lab. Finally configure the RIP routing. This is covered in the Configuring RIP lab if help is needed. Do not forget to save the configurations to the startup configuration file. 1 - 5 CCNA 2 Routers and Routing Basics v - Lab .
