Cable a network similar to one of the diagram. Any router that meets the interface requirements displayed on the above diagram, such as 800, 1600, 1700, 2500, 2600 routers, or a combination, may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise | Cisco SrsTEMS Lab Well-Known Port Numbers and Multiple Sessions Router designation Router name FA0 0 Address Subnet mask Enable secret password Enable VTY and Console passwords Router 1 GAD 192 168 class cisco Straight-through cable Serial cable Console Rollover Crossover cable Objective Enable HTTP services on a router. Show multiple HTTP and Telnet sessions on a single host. Observe well-known TCP port numbers on the host and router. Background Preparation Cable a network similar to one of the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800 1600 1700 2500 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 5 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Step 1 Configure the hostname passwords and interface on the Gadsden router a. On the Gadsden router enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. Configure the Ethernet interface. Step 2 Save the configuration information from the privileged EXEC command mode GAD copy running-config startup-config Step 3 Configure the host with the proper IP address subnet mask and default gateway Step 4 Allow HTTP access to the router a. Allow HTTP access by issuing the ip http server command in
