Tham khảo tài liệu 'lab configuring standard access lists', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | ClíCf SíịlE U9 Lab Configuring Standard Access Lists Straight-through cable Serial cable Rollover console cable Crossover cable Router Designation Router Name FA0 0 Address Subnet mask Enable Secret password Enable VTY Console passwords Router 1 GAD class cisco Objective Configure and apply a standard ACL to permit or deny specific traffic. Test the ACL to determine if the desired results were achieved. Background Preparation Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram such as 800 1600 1700 2500 and 2600 routers or a combination may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. Step 1 Configure the hostname and passwords on the Gadsden router a. On the Gadsden router enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. Configure the FastEthernet interface on the router according to the chart. 1 - 5 CCNA 2 Routers and Routing Basics v - Lab Copyright 2003 Cisco Systems Inc. Step 2 Configure the hosts on the Ethernet segment a. Host 1 IP address Subnet mask Default gateway b. Host 2 IP address Subnet mask Default gateway Step 3 Save the configuration information from the privileged
