When using “lane config auto-config-atm-address” in the LECS definition, this assumes that the 1010 switch is providing the LECS’ address through the “well known NSAP address”. On the 1010, use “atm lecs-address-default ” and point to the nsap address of the LECS router. Use “show lane default” on the router and cut and paste!! | ATM LANE Key Commands Shows and Debugs On Router Show lane default - very important Interface atm 0 Show atm arp Atm pvc 1 0 5 qsaal Debug atm arp Atm pvc 2 0 16 ilmi Show lane client LECS Show lane server for LES Lane database my database Show lane config for LECS Name elanl server-atm-address . check def Show lane database on LECS Name elan2 server-atm-address - LES addres Show lane bus start LECS Show lane le-arp interface atm 0 Show lane interfac e lane config my databse lane config auto-config-atm-address Start LES BUS Interface atm multipoint Lane server-bus Ethernet elan1 Start LEC Interface atm multipoint Lane client Ethernet elan1 Additional Commands On LANE module Exact same configs as on a router except for LEC Interface atm multipoint Lance client Ethernet 1 elan1 Maps the vlan 1 to elan1 Then can use sc0 in vlan1 On 1010 to point to the LECS through well known Atm lecs-address-default . On LECS if want to use a different address use Lane config fixed-atm-address Spot The Issue When using lane config auto-config-atm-address in the LECS definition this assumes that the 1010 switch is providing the LECS address through the well known NSAP address . On the 1010 use atm lecs-address-default . and point to the nsap address of the LECS router. Use show lane default on the router and cut and paste Élan names are CASE SENSITIVE The selector byte is the number of the subinterface on which the service resides. In HEX Notes If possible allowed put all Lane services on the same router instead of spreading it. You MUST put the services under subinterfaces except for LECS. Write down the sub-interface because it matters with the NSAP address of services when mapping them. Check show lane default to see the default nsap addresses with . The value of the selector byte corresponds to the sub-interface number of the atm interface Notice that in show lane default the LECS address is .00 while all others are . . This is because the LECS
