Objective: The objective of this exercise is configure Sydney and Melbourne (refer diagram 1) for remote frame relay switching. As such they will tunnel frame relay traffic between the 2 serial0 interfaces by encapsulating this traffic in IP and sending it across an IP backbone. | Table of contents Exercise 1 Remote frame relay switching 2 Exercise 2 IP across frame relay 3 Exercise 3 IPX across frame relay 4 Exercise 4 Appletalk across frame relay 5 Exercise 5 Decnet across frame relay 6 Exercise 6 Banyan vines across frame relay 7 Exercise 7 Trouble shoot your network 8 Exercise 8 DLCI prioritization 9 Exercise 9 Stun and 10 Exercise 10 Hot standby router protocol HSRP 11 Exercise 11 Advanced bgp-4 12 Exercise 12 EIGRP 13 Exercise 13 IPX 14 Exercise 14 Auto install 15 Exercise 15 IGRP-BGP-OSPF 16 Exercise 16 Policy routing 17 Exercise 17 Network Address Translation 18 Exercise 18 Protocol translation 19 Exercise 19 Route tagging 20 Exercise 20 CLNS and IS-IS 21 Exercise 21 DLSW 22 Exercise 1 Remote frame relay switching Objective The objective of this exercise is configure Sydney and Melbourne refer diagram 1 for remote frame relay switching. As such they will tunnel frame relay traffic between the 2 serialO interfaces by encapsulating this traffic in IP and sending it across an IP backbone. a Cable your routers as shown on diagram 1. Gibe all 4 routers appropriate hostnames and passwords. Also add clocking on serial interfaces. Do NOT clock faster then if you have cables. b Use network and a 20 mask to create 3 subnets. c Configure Sydney and Melbourne Ethernet0 for IP routing using of the allocated subnets. d Create one loopback interface on each of Melbourne and Sydney and assign each an IP address from the remaining 2 subnets. e On Sydney and Melbourne configure RIP to advertise network f Create a tunnel connecting Melbourne and Sydney across the Ethernet IP backbone Use the loopback interfaces as end points. g Configure Melbourne and Sydney as frame relay FR switches on serial 0. Create 2 PVC s at each end. Assign them DLCI numbers 50 and 51. h Connect Brisbane Canberra to Melbourne Sydney via their serial 0. Create 2 PVC s between Brisbane and Canberra. Use a NBMA approach ie. No .
