In this lab, you configure a combination of advanced routing features to optimize routing. These features include distribute lists, passive interfaces, default routes, and route redistribution. | Configuring Distribute Lists and Passive Interfaces In this lab you configure a combination of advanced routing features to optimize routing. These features include distribute lists passive interfaces default routes and route redistribution. Scenario International Travel Agency ITA uses RIPv2 for dynamic routing. You do a performance analysis to determine whether RIPv2 is optimized. A very slow Kbps link is used to connect Singapore and Auckland until you can provision a faster link. To reduce traffic you would like to avoid dynamic routing on this link. You notice that one of the LANs with enterprise servers is near saturation. To reduce traffic you decide to filter RIPv2 updates from entering SanJose3 s 24 Ethernet LAN because the updates serve no purpose. ITA has a large research and development division in Singapore. The R D engineers are on LAN 24. The R D managers on the 24 LAN need access to this experimental network but you also want this LAN to be invisible to the rest of the company. Also the two R D LANs have many UNIX hosts that need to exchange RIPv2 updates with the Singapore router. 1 - 7 Semester 5 Advanced Routing - Lab Copyright 2001 Cisco Systems Inc. Step 1 Build and configure the network according to the diagram but do not configure RIPv2 yet. Use ping to verify your work and test connectivity between the serial interfaces. Note Auckland should not be able to ping SanJose3 until you have made additional configurations. Step 2 On SanJose3 configure RIPv2 to advertise both connected networks as shown here SanJose3 config router rip SanJose3 config-router version 2 SanJose3 config-router network SanJose3 config-router network No routers or hosts on SanJose3 s Ethernet LAN need RIPv2 advertisements. However if you don t include the network in the RIPv2 configuration SanJose3 will not advertise the network to Singapore. However you can configure .
