International Travel Agency maintains two WAN links from the West Tasman (., Westaman) site to its core network / link is full T1 ( Mbps), and the other is a fractional T1 with a capacity of 768 Kbps. Under OSPF, West Tasman prefers the Full T1 link by virtue of its higher bandwidth (and lower cost). However, the Network Operations Center has decreed that all traffic from the LAN bound to /24 should use the slower fractional T1 link until further notice. You are to apply this policy by configuring a route map on the West Tasman router | Configuring Route Maps S0 0 30 Host B 24 Host C 24 S0 0 30 testaman Full T1 Mbps Fa0 0 24 Fậ0 1 24 OSPF AREA 1 fa Host A 24 anJosel Fa0 0 24 S0 1 30 Fractional T1 768 Kbps S0 0 30 Fa0 0 24 anJose Objective In this lab you apply a routing policy by configuring a route map. Scenario International Travel Agency maintains two WAN links from the West Tasman . Westaman site to its core network link is full T1 Mbps and the other is a fractional T1 with a capacity of 768 Kbps. Under OSPF West Tasman prefers the Full T1 link by virtue of its higher bandwidth and lower cost . However the Network Operations Center has decreed that all traffic from the LAN bound to 24 should use the slower fractional T1 link until further notice. You are to apply this policy by configuring a route map on the West Tasman router. Step 1 Build and configure the network according to the diagram but do not change the any interface bandwidth settings yet. Configure all interfaces for OSPF area 0. Configure Host A and Host B with IP addresses and default gateways as indicated in the diagram. Initially configure the serial links for equal-cost share. . do not configure the serial link bandwidth statements at this time. Note Use SanJose1 as Host A s gateway. Use ping and show ip route to verify your work and test connectivity between all interfaces and hosts. 1 - 5 Semester 5 Advanced Routing - Lab Copyright 2001 Cisco Systems Inc. Step 2 Check the routing table on Westasman Westasman show ip route Gateway of last resort is not set C 24 is directly connected FastEthernet0 0 C 24 is directly connected FastEthernet0 1 30 is subnetted 2 subnets is directly connected Serial0 0 is directly connected Serial0 1 C C 24 is subnetted 1 .
