cắt Openings Các thành phần có thể cắt giảm một mở trên một mặt, vì vậy nếu bạn đang làm việc với hai mặt (hoặc hai mặt) bức tường, khuôn mặt trở lại sẽ không được cắt giảm. Để tạo ra khe hở trên cả hai khuôn mặt, bạn cần một vài bước mở rộng. | Painting Materials and Textures 8. The red pin is the anchor pin. Scaling shearing rotation and distortion are all done relative to this pin. Click and drag the red pin to the lower left corner of the face. You can access inference points like endpoints and midpoints while in position mode. Now Block 1 will always start at the lower left corner of this face. 9. The green pin is used for overall scaling and or rotation. Right now we will use it just for scaling. Drag the green pin to the lower right corner. Now three full stone blocks fill the face horizontally. 10. In addition to dragging pins you can also move them. Hover over the green pin until you see a small square around it then click. This lifts the pin out of its position. Move the mouse to the point between Blocks 2 and 3 and click to place the pin there. The point of the pin not the pin body determines the pin s location. 11. Now drag the green pin back to the lower right corner. Two blocks are now spaced along the face. The blue pin is for shearing making diagonal as well as vertical scaling. 12. Drag the blue pin up or down so that four rows of blocks fit vertically in the face. 191 the SketchUp Workbook Version 5 13. To accept this new position right-click and select Done. You can also click anywhere in blank space to exit position mode. 14. Now move the front face again. No matter where it s located the face contains two blocks along the bottom and four rows vertically. Also note that the rest of the model has the original texture position only the front face has changed. 15. Slope the front face by moving the edge shown. The yellow pin is used for out-of-plane distortion. The result only looks out of plane - the texture always remains on the face . This is more useful for actual photographic images that you re trying to fit to a face but we will use it here anyway. 16. Drag the yellow pin straight up so that the seam line above Blocks 1 2 and 3 is parallel to the diagonal edge. 17. Exit position mode
