While the final inspection in the QA is analysed, the machinist begins with the emptying of the cab. Under the discharge pipe a cardboard with a bag is placed. With the mill " product discharge cab " is switched on and more der"Timer ". | PB-Nr Cleaning 1 Cab powder - final discharge While the final inspection in the QA is analysed the machinist begins with the emptying of the cab. Under the discharge pipe a cardboard with a bag is placed. With the mill product discharge cab is switched on and more der Timer . In order also the powder which is at the cab walls to be able are the cab walls deliver with a rubber hammer to be knocked off. After termination of the discharge the cab powder bag with a quick-locking mechanism is closed and the cab powders - label glued on with the normal labels is output the bag with the cab powder is placed to the balance where it remains up to the system acceptance. 2 Driving out resin If the final sample was released can be begun with the actual flash. The driving out resin is emptied on the cooling tape. The filter body is fastened from the sieve jigger taken for which covers locked again put and a bag under the filter. Afterwards the filter is switched on. The mill is taken to rotor and separator excluded in operation the granulator and the cooling tape are switched on. Thus the driving out resin is granulated and the mill is prepurified. The granulated driving out resin is provided with a label and placed like the cab powder beside the balance. 3__Cleaning Always it can be said that the cleaning river corresponds to the flow of material 3-1 Zwischendeck The tanker is pulled away with the systems which have a direct filling. The filler neck is taken and cleaned from the funnel charging hole. The various lines the cab the fan as well as the tanker are cleared away. The intermediate bottom is cleaned within the finery area of the system. 3-2 Funnels The funnel is output-turned with a small broom. Issued by Hr. Demmelmayer Date of release Version 00 Page 1 3 PB-Nr Cleaning The gutter-pipe is removed and the funnel discharge cover is unscrewed. Now the auger with a brush or a small broom can be cleaned. 3-3 Extrusionr The extrusion .
