một mong muốn để tìm hiểu họ, sau đó bạn có thể. Và một khi bạn biết những điều cơ bản, bạn có thể xây dựng! Bạn có thể học hỏi như bạn đi. Theo tôi, tốt nhất là để làm điều này ít nhất một lần. Nếu bạn đi mua một máy tính được xây dựng trước của HP hoặc Compaq, họ cũng tốt. | 3. Insert the Processor. It is time to insert the processor into the Slot. The processor has one card-like edge at the bottom of the black cartridge. This edge is keyed so that it can only insert into the slot the correct way. So push the processor into the guide rails and down all the way to the surface of the slot. Make sure the cooler or fan is facing the side near the motherboard s chipset. When you get to the bottom you will feel some resistance. This is normal. Work the processor in until the little levers at the top of the guide rails click into place locking the chip in This e-book is copyright to Glyn Williams. If you have purchased this book from elsewhere please e- mail glyn@ for a reward STEP 6 Install Heat Sink Fan As mentioned in the previous step slotted processors usually have the heat sink fan combo installed before the CPU is actually installed onto the motherboard. But with socket processors this cannot be done because the fan is actually clipped to the motherboard. Well I ll get right to it. Some of these steps are unnecessary on modern machines but are here for the sake of covering all setups. I will highlight these legacy steps in red. 1. Attach the fan to the heat sink. This step is almost always already done for you but if not you must do it yourself. This is done using the four screws that came with the CPU fan. 2. Apply the Heat Sink Compound. Heat sink compound is something that many do not use anymore myself included. But in some older systems it will be necessary. Or you may wish to in order to increase the conductivity of the heat from the processor into the heat sink. To do this apply just enough to cover the surface of the chip. If you have portions of the chip higher than others apply compound only to the raised areas. The layer should be thin. More won t hurt anything but will be a mess when you press the heat sink down. 3. Attach The Heat Sink. Place the heat sink fan combo squarely on top of the processor .
