ý thức tuân thủ chấp hành các quy định pháp luật của một số nhà đầu tư, doanh nghiệp chưa thật sự nghiếm túc; một số công trình xây dựng mà chưa có ý kiến của cơ quan chức năng và chính quyền địa phương; nhiều công trình, hạng mục hạ tầng viễn thông chưa được cấp giấy phép xây dựng nhưng chủ đầu tư vẫn thi công | e If the 220 V AC cabinet is configured with one UPEU refer to the following information m Note li the GATM1 GATM2 is not configured you should directly connect the signal cable to the next-level equipment. SN BOM Code Cable Name Installation Position Appearance 1 04070025 Monitoring signal cable for the FAN unit One end is connected to the COM IN port on the panel of the FAN other end is connected to the MONO port on the UPEU panel. 2 04070025 Monitoring signal cable for the GATM One end is connected to the COM OUT port on the panel of the FAN unit and the other end to the COM1 port on the GATM panel. 3 04070025 Monitoring signal cable for the GATM One end is connected to the MON1 port on the UEIU panel and the other end to the COM1 port on the GATM panel. 4 04080038 Monitoring signal cable for the EMUA The DB9 connector at one end is inserted into the RS485 port on the EMUA panel. At the Other end the cable is cut off and split before being inserted into the COM2 port on the GATM1 panel. V 5 04070023 Monitoring signal cable for the PM u One end is connected to the RS232 RS422 port on the PMU panel. At the other end the cable is cut off and split before being connected to the COM2 port on the GATM1 panel. 6 04080032 Monitoring signal cables for the DCDU-01 One end is connected to the EXT-ALM0 port on the UPEU panel. At the other end pins 1 and 2 are connected to the SPD ALM port on the DCDU-01 panel. W2 f t- I W1 7 04046100 BBU alarm cable One end is connected to the EXT-ALM1 port on the UPEU panel and the other end to the external alarm device. 39 a If the 220 V AC cabinet is configured with one UPEU and one UEIU refer to the following information SN BOM Code Cable Name Installation Position Appearance 1 04070025 Monitoring signal cable for the FAN unit One end is connected to the COM IN port on the panel of the FAN other end is connected to the MONO port on the UPEU panel. 2 04070025 Monitoring signal cable for the GATM One end is connected to
