ITC phủ sử dụng đầu ghi hoặc ngọn đuốc một tay để từ từ nâng cao để làm nóng da cam. Điều này ngăn cản các lớp phủ mới của cửa từ gắn bó với tấm chăn sợi gốm giả mạo. Liên kết vữa không khí sẽ chữa khỏi, nhưng ITC # lo0 phải được đun nóng để chữa trị. Bạn sẽ nhận thấy rằng cánh cửa sẽ không phù hợp rất xa vào việc mở cửa vào thời điểm này. | A Propane Bottle Gas Fired Forge ITC coating use the burner or a hand torch to slowly raise to orange heat. This prevents the new coating of the door from sticking to the ceramic fiber blanket in the forge. Bonding mortar will air cure but ITC 100 must be heated to cure. You will notice that the door will not fit very far into the opening at this point. The next step is to cut a recess into the Ceramic fiber blanket about 3 4-inch deep so that the door will fit into the pocket and may compress the ceramic fiber blanket another 1 8-inch to 3 16-inch. Fitting the door into a pocket gives it a more protected position. First trim any protruding blanket even with the shell opening then cut into the side of the fiber blanket with a small paring knife or pocket knife. Use the edge of the shell as a steady rest for the blade and cut straight into the end of the blanket. Use the thin strip that is removed to stuff between the burner and the collar before lowering the flat washer into place. Fill in any voids around the kiln shelf at the openings with slurry making sure these areas are heat cured before the door touches them. Fig. 5-10. On the left a front view of the forge showing its door and hardware but not the carrying handle. On the right a cutaway view of this half of the forge shows the door inset in the forge trapped between the fiber blanket and a u shaped bracket. Short ss wood screws pin the fiberboard door to the bracket. Rigidizer will strengthen their hold on the fiber. 17. Curing the forge The forge must be left to air dry for several days in warm weather in order to give most of the water content in the ITC 100 time to evaporate from the ceramic fiber blanket. Even after the interior looks dry there is some moisture content still trapped in the fiber lining. This must be slowly cooked out to prevent it from suddenly turning to steam and damaging the ITC 100 coating. After placing the door gently into its recess prop something that can withstand heat on .
