Nếu màn hình vẫn còn xuất hiện khiến bạn nhấn Next khi cài đặt được thực hiện, làm như vậy, và sau đó nhấn Finish. Kế hoạch của Microsoft Exchange Server 2003 cơ sở hạ tầng Theo dõi sự tiến bộ của tiến trình cài đặt | 4-10 Chapter 4 Coexistence with Microsoft Exchange Server Figure 4-2 Selecting ADC components to install 6. The next page of the wizard prompts you to choose an installation location. You can accept the default location of Program Files MSADC or you can choose a different location. After selecting an installation location click Next. 7. Next you must supply a service account to be used by the ADC service. The Account Name will default to the account you are currently logged in with. If you created a service account for Exchange Server use it instead. Enter the password as required and then click Next. 8. Setup copies the required files to your server and configures its service. Click Finish when it is done. If a screen still appears prompting you to click Next when the installation is done do so and then click Finish. Exercise 2 Prepare Exchange Server for Directory Synchronization 1. On Server01 from the Start menu point to Programs point to Microsoft Exchange and click Exchange Administrator. 2. Expand the Site container and then expand the Configuration container. Click the Protocols container and then double-click LDAP Directory Site Defaults. 3. Because Server01 is an Active Directory domain controller the default LDAP port 389 is already in use and cannot be used by the ADC. You will need to change the LDAP port to something else that is not in use so change the LDAP port number to 1389 and click OK. 4. From the Start menu point to Programs point to Administrative Tools and click Services. Restart the Microsoft Exchange System Attendant service and click Yes when prompted to restart all the services that depend on it. Close Services when done. Lesson 1 Connecting Exchange Server to Active Directory 4-11 Exercise 3 Configure Directory Synchronization Using ADC Tools To configure the ADC using ADC Tools perform the following steps 1. Click the ADC Tools link to the left of the Active Directory Connector Services console. Click Set. This will bring .
