Hộp thoại này không cung cấp bất kỳ tính năng để chuyển đổi giữa các phiên bản của Microsoft Office, nhưng nó chứa các thiết lập cho biết những gì trình duyệt được nhắm mục tiêu khi xuất khẩu một tài liệu từ một ứng dụng OpenOffice ở định dạng HTML. OpenOffice hỗ trợ một số định dạng, bao gồm | Adding a New Hard Disk are a few manual steps that we need to perform. Detecting the Hard Disk After hooking up the new hard disk to the system and before going any further it is necessary to ensure that the disk has been recognized by the operating system. Usually Red Hat s kudzu configuration tool will allow us to configure our new hardware when it is detected during the bootup process. To ensure that the new disk has been recognized we need to examine the kernel startup messages - these messages can be viewed using the dmesg command. We need to look for detection messages corresponding to our new hard disk. Here is a typical dmesg line which indicates that the new hard disk has been detected dmesg grep -i maxtor hdb Maxtor 90651U2 ATA DISK drive Note An alternative is to list the contents of proc partitions which lists all the currently available partitions including have not been mounted yet. Here is the listing of a typical proc partitions file. For our purposes it is sufficient tc new row in the table and note the name column in this case hdb. cat proc partitions major minor blocks name rio rmerge rsect ruse wio wmerge wsect wuse running use 22 0 661728 hdb 40 32 280 500 0 0 0 0 -24865 229742 3 0 6297480 hda 17031 21392 305170 253707 11959 16564 228632 422367 -1 657790 3 1 104391 hdal 35 85 240 408 14 6 40 244 0 636 3 2 5807497 hda2 16967 21086 304394 252974 11788 14238 208776 250927 0 188263 3 3 385560 hda3 9 25 104 146 157 2320 19816 171195 0 3453 If there are no kernel startup messages or listings in proc partitions then it is quite likely that the disk was not detected. There are several possible reasons for the system s failure to detect the disk. To eliminate the possibility of a hardware setup problem we should check all hardware settings such as the master-slave mode settings of the hard disk and compare them with the manufacturer s recommended settings. It s possible that the detection failure may have occurred because the correct driver is missing .
