(2.) Dựa trên các ZXPlane. Sử dụng dòng từ hộp công cụ Draw của tab Phác thảo để tạo ra các dòng. Để vị trí của nó, đặt điểm đầu tiên tại Z = 0 m, X = 0 m và sau đó đặt các điểm thứ hai ở góc gần chính xác, | Tutorial 10 Heating Coil 1. Create a new sketch based on the ZXPlane. 2. Use Line from the Draw Toolbox of the Sketching tab to create the line. To position it place the first point at Z 0 m X 0 m and then put the second point down at approximately the correct angle as shown in the picture below. 3. Now specify the exact angle as follows. Use the Dimensions section of the Sketching tab and choose Angle. Then click on the line and then on the X-axis. If the wrong angle is displayed after you have selected the axis then right-click and choose Alternate Angle until the correct angle is displayed. Click in the Model View to position the angle label. Finally type the angle degrees into the Dimensions box in the Details View. The Extrude operation can be used for this extrusion. 1. Select Extrude from the 3D Features Toolbar. 2. Set Base Object to be Sketch1 and set Operation to Add Material. 3. Click on Direction Vector to change it from just being None Normal . Right-click in the Tree View over Sketch3 and select Keep Visible then click on the single line in Sketch3 which defines the direction vector. Press Apply in the Details View. The text should now read 2D Edge. 4. Set Depth to be m and Merge Topology to No. Click on end of the coil. Generate to extrude the bottom Extruding the Top End of the Coil The actions above will be repeated to extrude the top part of the coil. However there is no existing sketch to use to extrude from. Instead you will create a new plane from the top circular end of the coil which can be used for this purpose. 1. Create a new plane . 2. Set Type to be From Face and Subtype to be Outline Plane. 3. Set Base Face to be the circular face at the top of the coil. This can be selected directly by clicking on it in the Model View. 96 CFX-Mesh Tutorials. . IP Inc. Section 1 Geometry Creation 4. Click on Generate to create the plane. The Extrude operation can again be used for this extrusion. 1. Select Extrude from the 3D Features .
