Tham khảo tài liệu 'mcgraw-hill build a remote controlled robot part 10', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Skin and Finishing Touches 103 FIGURE 6-22. Painting guide. FIGURE 6-23. Foam strip used to cover body gaps. 104 Chapter Six FIGURE 6-24. Platform skirt in place. Two smaller gaps that need to be covered are found where the two lower access panels on the top of Questor s lower framework meet. These small gaps are covered with T-shaped metal covers made from leftover metal flashing used to make the robot s skin. The strips are held in place by the screws that hold the access panels to its mounting tabs. Figure 6-25 shows what the covers look like and how they are held in place. The last detail to take care of is to cover the surface of Questor s serving tray with black felt. The felt helps keep items on the tray from shifting when the robot moves. The felt is available with a sticky backing so all you need to do is cut it to fit and stick it in place. Make sure that you obtain felt that is waterproof so the color will not run when it gets wet from drinks carried on the tray. This last little detail completes Questor s construction. Skin and Finishing Touches 105 FIGURE 6-25. T-shaped gap cover for lower access .
