Mould Line Gas Springs and Spring Plungers for Mould Making For all applications where lift movements are required parallel to mould opening, it is possible to use gas springs. The FIBRO Mould Line gas spring (FML), which was specially developed for mould making, is characterised by its high force, its small size, a long service life of at least 1,000,000 strokes and a constant operating temperature of 120°C. Of course, the FML gas springs are approved as per the European Pressure Equipment Directive 97/23/EG. | . i ll or Mould Making II Mould Line I Gas Springs nd Sprang Plungers - Temperatures up to 120 C - specially developed for mould making 11 2007 97 23 PED io nmOO . 3479. Mould Line Gas Springs and Spring Plungers for Mould Making For all applications where lift movements are required parallel to mould opening it is possible to use gas springs. The FIBRO Mould Line gas spring FML which was specially developed for mould making is characterised by its high force its small size a long service life of at least 1 000 000 strokes and a constant operating temperature of 120 C. Of course the FML gas springs are approved as per the European Pressure Equipment Directive 97 23 EG. Advantages of the FIBRO Mould Line series Lower calibrating costs No lubrication required Maintenance-free up to 1 000 000 strokes1 Force variably adjustable For mould temperatures of up to 120 C Approved as per the European Pressure Equipment Directive 97 23 EG Standard safety features FIBRO Safer Choice 2 Safety piston rod Excess pressure protection Overstroke protection By means of a pressure monitoring system an impending failure can be recognised at an early point prevention No tool breakage should the 2nd separation level lock the plate comes to a standstill after the removal of the jam production can be resumed Worldwide usage a million times over of FIBRO Gas Springs Cost savings approximately 60-70 . compared to a latch-locking unit 1at 120 C strokes 2depending on the spring type Gas Springs . Spring Plungers 3479. . 1 2 subject to alterations . 3479. Mould Line Gas Springs and Spring Plungers for Mould Making Dimensions for Gas Springs . Order no Stroke max 10 13 16 19 25 32 38 50 63 75 80 100 125 d di c e f g h j r . l 0 25 50 56 62 68 80 94 106 130 156 180 190 230 280 16 31 9 12 5 4 3 5 2 M6 20 1 l min 40 43 46 49 55 62 68 80 93 105 110 130 155 . l 0 25 50 56 62 68 80 .
