Nghệ thuật xếp hình: buck_the_bunny tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Buck The Bunny By Perry Bailey 1998 1999 Take a dollar bill or a piece of paper around the same dimensions fold it in half the long way then unfold. I am using a dollar bill starting front side up crease it then turn it over. Make a Water bomb base while folding model in half. side of the WB base. Inside reverse fold the length of the bill back from about the half way mark of the top or bottom Reverse fold the bottom flap up to form front paws Make a Rabbits ear fold on each side of the head. of the WB base. Body not shown head and front only here. This is shown enlarge to make it possible to see the fold lines. Squash down the ears on both sides. Body not shown head and front only here. Still in enlarged mode Reverse fold the front to make a nose the top part of the nose will co-operated if you force it to much like a small child or an exspouse. Do an uneven double rabbits ear fold along the lines shown to finish the ears. Then we shrink the picture back down. Now crimp fold the rear part of the bill from about 1 3 from the front on top to about 1 3 from the back on the bottom. You should come out something like this. Now we need to work inside the model so the next view is interior of the model. We make an uneven rabbits ear to get excess paper up inside of the model do both sides. This is how it should look after our thinning the model out with the preceding fold. Now do a double inside reverse fold to form the haunches. Swivel fold up the legs on each side. I used the back of the bill to give you helpful reference points. Crimp fold the head downwards so it is even on both sides. Then open up the model to lock the head in to place. See next diagram This is inside the model and magnified to lock the head in to place just use a simple valley fold on the tip of the crimped material. Then you are done Just for continuity here is the finished model still in the attitude you started with. While I designed it to sit up it can go on all fours. It just might tend to .
