Arduino microcontroller based underground cable fault distance locator

The growing concern for safety and infrastructural proliferations in the densely populated urban and suburban areas as well as the quest to preserve the aesthetic values in many modern localities have necessitated the need for underground installations. | Arduino microcontroller based underground cable fault distance locator International Journal of Mechanical Engineering and Technology IJMET Volume 10 Issue 03 March 2019 . Article ID IJMET_10_03_092 Available online at http ijmet JType IJMET amp VType 10 amp IType 3 ISSN Print 0976-6340 and ISSN Online 0976-6359 IAEME Publication Scopus Indexed ARDUINO MICROCONTROLLER BASED UNDERGROUND CABLE FAULT DISTANCE LOCATOR Samuel A. Isaac Olajube Ayobami Awelewa Ayokunle Utibe Bassey Electrical and Information Engineering department College of Engineering Covenant University Ota Nigeria. ABSTRACT The growing concern for safety and infrastructural proliferations in the densely populated urban and suburban areas as well as the quest to preserve the aesthetic values in many modern localities have necessitated the need for underground installations. The underground cabling installations are devoid of faults common to the overhead transmission lines but are associated with certain kinds of faults such as short circuit and open circuit faults. Locating the exact position of any of these kinds of faults is very exhausting costly and time-consuming because its power distribution system is invisible. Hence a microcontroller based underground cable fault distance locator powered by Arduino is designed to detect and pinpoint location of faults in underground cable lines. A basic ohm s law is employed to achieve the variation of current with respect to resistance that determines the position of the fault. This device has a power supply unit cable unit control unit tripping unit and display unit. The power supply unit provides power to the other components. The cable unit consists of a three-phase cabling system with switches between each phase to activate faults. The control unit takes in signals from the cable unit to cause control of tripping unit and display unit. The tripping unit then detects the phase which encounters the fault and the display

Không thể tạo bản xem trước, hãy bấm tải xuống
TÀI LIỆU MỚI ĐĂNG
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.