Đang chuẩn bị liên kết để tải về tài liệu:
CCNA ewan _part3

CCNA Exploration Truy cập mạng WAN: Frame Relay Lab 3.5.1 Frame Relay cơ bản R1 giao diện nối tiếp 0/0/1 ip địa chỉ 10.1.1.1 255.255.255.252 tắt máy Các giao diện nối tiếp nên vẫn còn tắt máy cho đến khi Frame Relay switch là cấu hình giao diện fastethernet 0 / 0 địa chỉ ip 192.168.10.1 255.255.255.0 không có bộ định tuyến tắt máy eigrp! | CCNA Exploration Accessing the WAN Frame Relay Lab 3.5.1 Basic Frame Relay R1 interface serial 0 0 1 ip address 10.1.1.1 255.255.255.252 shutdown The serial interfaces should remain shutdown until the Frame Relay switch is configured interface fastethernet 0 0 ip address 192.168.10.1 255.255.255.0 no shutdown router eigrp 1 no auto-summary network 10.0.0.0 network 192.168.10.0 R2 interface serial 0 0 1 ip address 10.1.1.2 255.255.255.252 shutdown The serial interfaces should remain shutdown until the Frame Relay switch is configured interface loopback 0 ip address 209.165.200.225 255.255.255.224 router eigrp 1 no auto-summary network 10.0.0.0 network 209.165.200.0 Task 3 Configure Frame Relay You will now set up a basic point-to-point Frame Relay connection between routers 1 and 2. You first need to configure FR Switch as a Frame Relay switch and create DLCIs. What does DLCI stand for What is a DLCI used for What is a PVC and how is it used This is trial version All contents are Copyright 1992-2007 Cisco Systems Inc. All rightslbserved. This document is Cisco Public Information. Page 4 of 24 www.adultpdi.com CCNA Exploration Accessing the WAN Frame Relay Lab 3.5.1 Basic Frame Relay Step 1 Configure FR Switch as a Frame Relay switch and create a PVC between R1 and R2. This command enables Frame Relay switching globally on the router allowing it to forward frames based on the incoming DLCI rather than on an IP address basis FR-Switch config frame-relay switching Change the interface encapsulation type to Frame Relay. Like HDLC or PPP Frame Relay is a data link layer protocol that specifies the framing of Layer 2 traffic. FR-Switch config interface serial 0 0 0 FR-Switch config clock rate 64000 FR-Switch config-if encapsulation frame-relay Changing the interface type to DCE tells the router to send LMI keepalives and allows Frame Relay route statements to be applied. You cannot set up PVCs using the frame-relay route command between two Frame Relay DTE interfaces. .