Đang chuẩn bị liên kết để tải về tài liệu:
Configuring Frame Mode MPLS

Configure the loopback interfaces with the addresses shown in the topology diagram. Also configure the serial interfaces shown in the diagram. Set the clock rate on the appropriate interface and issue the no shutdown command on all serial connections. Verify that you have connectivity across the local subnet using the ping command. | 111 111 CISCO Lab 4.1 Configuring Frame Mode MPLS Learning Objectives Configure EIGRP on a router Configure Label Distribution Protocol on a router Change the size of the Maximum Transmission Unit MTU Verify MPLS behavior Topology Diagram Scenario In this lab you will configure a simple Enhanced Interior Gateway Routing Protocol EIGRP network to route IP packets. You will run Multiprotocol Label Switching MPLS over the IP internetwork to fast-switch Layer 2 frames. Step 1 Configure Addressing Configure the loopback interfaces with the addresses shown in the topology diagram. Also configure the serial interfaces shown in the diagram. Set the clock rate on the appropriate interface and issue the no shutdown command on all serial connections. Verify that you have connectivity across the local subnet using the ping command. 1 - 12 CCNP Implementing Secure Converged Wide-area Networks v5.0 - Lab 4-1 Copyright 2007 Cisco Systems Inc R1 config interface loopback 0 Rl config-if ip address 172.16.1.1 255.255.255.0 R1 config-if interface fastethernet 0 0 R1 config-if ip address 172.16.12.1 255.255.255.0 R1 config-if no shutdown R2 config interface loopback 0 R2 config-if ip address 172.16.2.1 255.255.255.0 R2 config-if interface fastethernet 0 0 R2 config-if ip address 172.16.12.2 255.255.255.0 R2 config-if no shutdown R2 config-if interface serial 0 0 1 R2 config-if ip address 172.16.23.2 255.255.255.0 R2 config-if clockrate 64000 R2 config-if no shutdown R3 config interface loopback 0 R3 config-if ip address 172.16.3.1 255.255.255.0 R3 config-if interface serial 0 0 1 R3 config-if ip address 172.16.23.3 255.255.255.0 R3 config-if no shutdown Step 2 Configure EIGRP AS 1 Configure EIGRP for AS1 on all three routers. Add the whole major network 172.16.0.0 and disable automatic summarization. R1 config router eigrp 1 R1 config-router no auto-summary R1 config-router network 172.16.0.0 R2 config router eigrp 1 R2 config-router no auto-summary R2 config-router network .