Đang chuẩn bị liên kết để tải về tài liệu:
Cisco Network part 84

Không đóng trình duyệt đến khi xuất hiện nút TẢI XUỐNG Tải xuống

Tham khảo tài liệu 'cisco network part 84', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | ip policy route-map LOOPNAT ip nat inside source list 1 interface Ethernet0 overload access-list 1 permit 10.0.0.0 0.255.255.255 route-map LOOPNAT permit 10 match ip address 1 set interface Loopback0 Note that Lo0 interface may have any ip address. From Question 29 Subject How do I hide a summarized OSPF router from one ABR to another area 1 range x.x.x.x x.x.x.x not-advertise From Question 30 Subject How do I setup Windows 2000 and IPSec to PIX FIrewall To describe how to use the Local Security Policy MMC in W2K would take a long time. So the config I will share with you is the dial-up one I mentioned before. In this posting I will detail the bare minimum needed to get a W2K client working with a PIX firewall running v6.01 software. For simplicity I use a preshared key for authentication. Since I have to embed this key into the script I use it makes the configuration open and thus vulnerable. However you should be able to tweak the configuration from this to meet your own security needs. The W2K IPSec client supports certificates as well as preshared keys so a secure version of this config is attainable. The configuration script I eked it isn t beautiful code out is actually written in Perl. If you would like to re-write it in the old DOS batch file format please do so. Otherwise you should find a copy of Perl for NT W2K. I use the version found at http www.activestate.com. The Perl script I show here is documented as to what it does. The MS ipsecpol.exe program that you have to use has it s own documentation which you should read. For the PIX I give you only the crypto isakmp and sysopt commands you need to issue to your PIX to make this config work. The config assumes that the PIX has NAT enabled. Ok enough blabber here it is. I hope it is helpful For the purposes of this demo config. The PIX Firewall will have 192.168.0.1 as it s outside IP. The inside network will be the 10.0.X.X network. The inside router will be 10.0.0.1 Quick Network Schematic W2K -- .