Đang chuẩn bị liên kết để tải về tài liệu:
News Overhead Models

Không đóng trình duyệt đến khi xuất hiện nút TẢI XUỐNG Tải xuống

It replaces the viscous clutch in four-wheel drive. As soon as a difference in speed comes about between front and rear axle, the swash plate begins to turn. In this, it operates the pump plunger, which presses hydraulic oil into the plunger of the friction disks. After less than one revolution, adhesion has resulted. The base is actuated by closing the switch. The With the help of the electronically operated throttle collector emitter line becomes conductive, the lamp valve, the slip can be adapted to the driving lights up. This can be. | HAKO Overheadmodels - News Order no. 430 Torque converter lock-up clutch Functions - Power flow from the converter housing via the pump stator and turbine to the inlet shaft of the gearbox with the lock-up switched off. - The hydraulic piston is pressed onto the friction disks with the help of the oil pressure - The power flow now runs from the converter housing directly to the inlet shaft the slip is switched off. Order no. 429 Haldex clutch It replaces the viscous clutch in four-wheel drive. As soon as a difference in speed comes about between front and rear axle the swash plate begins to turn. In this it operates the pump plunger which presses hydraulic oil into the plunger of the friction disks. After less than one revolution adhesion has resulted. With the help of the electronically operated throttle valve the slip can be adapted to the driving situation in question. Order no. 427 Transistor The base is actuated by closing the switch. The collector emitter line becomes conductive the lamp lights up. This can be shown clearly with the help of the water analogy. When the small flow of water reaches the base this flow of water opens the slide and makes the way free for the large water flow collector emitter line the water can flow. Order no. 434 Cylinder shutoff The cylinder shutoff a new development for the new Daimler Benz S class is switched on and off electro-hydraulically by the control unit. In the lower load area 4 cylinders are switched off in the upper load area there is a switch-over to 8 cylinders. The valves are operated in a locked state. If the coupling pins are removed the valves remain closed. The driving levers are pressed onto the camshaft by springs in an unlocked state. Order no. 437 Spring leg air suspension Used in the Daimler Benz S class. - Function of a modern car air suspension - Function of the level control - Function of the damping and the various damping strengths TECHNOLAB SA Rotherdweg 16 Postfach CH-5022 Rombach - Switzerland Tel