Đang chuẩn bị liên kết để tải về tài liệu:
Sổ tay tiêu chuẩn thiết kế máy P54

Tham khảo tài liệu 'sổ tay tiêu chuẩn thiết kế máy p54', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | CHAPTER 47 ROBOTS AND SMART MACHINES Kenneth J. Waldron Ph.D. Professor of Mechanical Engineering The Ohio State University 47.1 INTRODUCTION 47.1 47.2 DESIGN AND FUNCTION I 47.6 47.3 STRUCTURAL DESIGN 47.8 47.4 ACTUATION AND POWER TRANSMISSION SYSTEMS 47.12 47.5 SENSING SYSTEMS 47.17 47.6 COMPUTER HARDWARE AND SOFTWARE ORGANIZATION 47.21 47.7 CONTROLLER DESIGN 147.26 47.8 GEOMETRIC DESIGN 47.29 47.9 TOOL DESIGN 47.39 REFERENCES 47.39 47.1 INTRODUCTION 47.1.1 Elements of a Robot System In recent years the so-called industrial robot has become a familiar feature of manufacturing plants. This class of machines is of course only a part of a much more diverse family of devices characterized by large numbers of degrees of freedom and intelligent controllers. Industrial robots are however by far the most numerous visible and economically important group of devices in this family. For this reason much of the material in this chapter is directed at industrial robot design although an attempt is made to place them in an overall context of intelligent mechanical systems. Figure 47.1 indicates the hardware subsystems present in a generalized industrial robot system. The manipulator usually has six independently actuated joints because a body which moves freely in space has six degrees of freedom. Consequently if the hand of the manipulator is to be placed in an arbitrary position and orientation within the manipulator s reach then the mechanism must have six degrees of freedom. Nevertheless some industrial robots on the market have as few as four or as many as seven degrees of freedom. Some types of tasks do not require the full six degrees of freedom and can be handled by four- or five-degree-of-freedom robots. Because the joints usually are not capable of complete rotation but can move only over a restricted angular range additional degrees of freedom beyond the basic six are often useful for demanding manipulative operations. The joints may be actu- 47.1 47.2 STANDARD .