Đang chuẩn bị liên kết để tải về tài liệu:
Lab 3.1.7 Configuring an Ethernet Interface

Không đóng trình duyệt đến khi xuất hiện nút TẢI XUỐNG Tải xuống

In this lab the Cisco Discovery Protocol (CDP) commands will be used. CDP discovers and shows information about directly connected Cisco devices (routers and switches). Any router that meets the interface requirements may be used. Possible routers include 800, 1600, 1700, 2500 and 2600 routers, or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly different output. The following steps are intended to be executed on each. | Cisco SrsTEMS Lab 3.1.7 Configuring an Ethernet Interface Straight-through cable Serial cable Rollover console cable Crossover cable Router Designation Router Name Router Type FA0 0 Address Subnet mask Enable Secret password Enable VTY Console passwords Router 1 GAD 192.168.14.1 255.255.255.0 class cisco Objective Configure an Ethernet interface on the router with an IP address and a subnet mask. Background Preparation In this lab the Cisco Discovery Protocol CDP commands will be used. CDP discovers and shows information about directly connected Cisco devices routers and switches . Any router that meets the interface requirements may be used. Possible routers include 800 1600 1700 2500 and 2600 routers or a combination. Refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. Step 1 Configure the hostname and passwords on the Gadsden router a. On the Gadsden router enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console virtual terminal and enable passwords. 1 - 4 CCNA 2 Routers and Routing Basics v 3.0 - Lab 3.1.7 Copyright 2003 Cisco Systems Inc. Step 2 Configure the fastEthernet 0 interface GAD config interface fastEthernet 0 GAD config-if ip address 192.168.14.1 255.255.255.0 GAD config-if no shutdown GAD config-if exit GAD config exit Note Once interface configuration mode is entered note the ip address of the interface. Enter the subnet mask. The .